Set Igmp Interfacemode All; No Set Igmp Interfacemode All; Set Igmp Maxresponse; No Set Igmp Maxresponse - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format
Mode

set igmp interfacemode all

This command enables IGMP Snooping on all interfaces. If an interface which has IGMP
Snooping enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will
subsequently be re-enabled if routing is disabled or port-channel (LAG) membership is removed
from an interface that has IGMP Snooping enabled.
Default
Format
Mode

no set igmp interfacemode all

This command disables IGMP Snooping on all interfaces.
Format
Mode

set igmp maxresponse

This command sets the IGMP Maximum Response time on the system. The Maximum Response
time is the amount of time in seconds that a switch will wait after sending a query on an interface
because it did not receive a report for a particular group in that interface. This value must be less
than the IGMP Query Interval time value. The range is 1 to 3599 seconds.
Default
Format
Mode

no set igmp maxresponse

This command sets the IGMP Maximum Response time on the system to 10 seconds.
Format
Mode
Switching Commands
no set igmp groupmembership-interval
Global Config
disabled
set igmp interfacemode all
Global Config
no set igmp interfacemode all
Global Config
10
set igmp maxresponse <1-3599>
Global Config
no set igmp maxresponse
Global Config
202-10088-01, March 2005
8-107