No Hardware-Address; Host; No Host; Ip Dhcp Excluded-Address - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Default
Format
Mode

no hardware-address

This command removes the hardware address of the DHCP client.
Format
Mode

host

This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
The prefix-length is an integer from 0 to 32
Default
Format
Mode

no host

This command removes the IP address of the DHCP client.
Format
Mode

ip dhcp excluded-address

This command specifies the IP addresses that a DHCP server should not assign to DHCP clients.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Default
Format
8-84
ethernet
hardware-address <hardwareaddress> [type]
DHCP Pool Config
no hardware-address
DHCP Pool Config
none
host <address> [mask | prefix-length]
DHCP Pool Config
no host
DHCP Pool Config
none
ip dhcp excluded-address <lowaddress> [highaddress]
202-10088-01, March 2005
Switching Commands