User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Modes
classofservice ip-precedence-mapping
This command maps an IP precedence value to an internal traffic class. The ipprecedence and
trafficclass can both range from 0-7, although the actual number of available traffic classes
depends on the platform. The 'no' form of this command is not supported.
Format
Modes
classofservice trust
This command sets the class of service trust mode of an interface. The mode can be set to trust one
of the Dot1p (802.1p), IP Precedence, or IP DSCP packet markings.
Format
Mode
no classofservice trust
This command sets the interface mode to untrusted.
Format
Modes
cos-queue max-bandwidth
This command specifies the maximum transmission bandwidth limit for each interface queue.
Also known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so
that the transmitted traffic rate is bounded. The total number of queues supported per interface is
platform specific.
Format
Modes
Quality of Service (QoS) Commands
Global Config
Interface Config
classofservice ip-precedence-mapping <ipprecedence>
<trafficclass>
Global Config
Interface Config
classofservice trust <dot1p/ip-precedence/ip-dscp>
Global Config
Interface Config
no classofservice trust
Global Config
Interface Config
cos-queue max-bandwidth <bw-0> <bw-1> ... <bw-n>
Global Config
Interface Config
202-10088-01, March 2005
11-41