Set Garp Timer Leaveall All; No Set Garp Timer Leaveall All; Show Garp - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Note:
This command has an effect only when GVRP is enabled
Format
Mode

set garp timer leaveall all

This command sets how frequently
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds.
Note:
This command has an effect only when GVRP is enabled
Default
Format
Mode

no set garp timer leaveall all

This command sets how frequently
(10 seconds). .
Note: This command has an effect only when GVRP is enabled.
Format
Mode

show garp

This command displays Generic Attributes Registration Protocol (GARP) information.
Format
Mode
GMRP Admin Mode
GVRP Admin Mode
Switching Commands
no set garp timer leaveall
Interface Config
are generated for all ports. A
Leave All PDUs
1000
set garp timer leaveall all <200-6000>
Global Config
are generated for all ports to 1000 centiseconds
Leave All PDUs
no set garp timer leaveall all
Global Config
show garp
Privileged EXEC and User EXEC
This displays the administrative mode of GARP Multicast Registration Protocol
(GMRP) for the system.
This displays the administrative mode of GARP VLAN Registration Protocol
(GVRP) for the system
202-10088-01, March 2005
.
.
Leave All PDU
8-99