Show Spanning-Tree Interface - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Root Port Bridge Forward Delay Derived value
Hello Time
Configured value
Bridge Hold Time
Bridge Max Hops
CST Regional Root
Regional Root Path Cost
Associated FIDs
Associated VLANs
When the "brief" optional parameter is included, this command displays spanning tree settings for
the bridge. In this case, the following details are displayed.
Bridge Priority
Bridge Identifier
Bridge Max Age
Bridge Max Hops
Bridge Hello Time
Bridge Forward Delay
Bridge Hold Time

show spanning-tree interface

This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot/port> is the desired switch port. The following details are
displayed on execution of the command.
Format
Mode
Hello Time
Port mode
Port Up Time Since Counters Last Cleared
8-136
Minimum time between transmission of Configuration Bridge Protocol Data
Units (BPDUs)
Bridge max-hops count for the device.
List of forwarding database identifiers currently associated with this instance.
List of VLAN IDs currently associated with this instance.
Configured value.
Configured value.
Bridge max-hops count for the device.
Configured value.
Configured value.
Minimum time between transmission of Configuration Bridge
Protocol Data Units (BPDUs)
show spanning-tree interface <slot/port>
Privileged EXEC and User EXEC
Admin hello time for this port
Enabled or disabled
minutes, and seconds.
202-10088-01, March 2005
.
Time since port was reset, displayed in days, hours,
Switching Commands