Show Msglog; Show Running-Config - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Static
Learned
Management
Self
GMRP Learned
Other

show msglog

This command displays the message log maintained by the switch. The message log contains
system trace information.
The trap log contains a maximum of 256 entries that wrap.
Format
Mode
Message
Note: Message log information is not retained across a switch reset.

show running-config

This command is used to display the current setting of different protocol packages supported on
switch. This command displays only those parameters, the values of which differ from default
value. The output is displayed in the script format, which can be used to configure another switch
with same configuration.
Format
8-14
The value of the corresponding instance was added by the system
or a user when a static MAC filter was defined. It cannot be
relearned.
The value of the corresponding instance was learned by observ-
ing the source MAC addresses of incoming traffic, and is cur-
rently in use.
The value of the corresponding instance (system MAC address) is
also the value of an existing instance of dot1dStaticAddress. It is
identified with interface 0/1 and is cur
VLANs for routing.
The value of the corresponding instance is the address of one of
the switch's physical interfaces (the system's own MAC address).
The value of the corresponding was learned via GMRP and
applies to Multicast.
The value of the corresponding instance does not fall into one of
the other categories.
show msglog
Privileged EXEC
The message that has been logged.
show running-config
202-10088-01, March 2005
rently used when enabling
Switching Commands