Show Ip Rip Interface - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

show ip rip interface

This command displays information related to a particular RIP interface.
Format
Mode
Interface
IP Address
Send version
Receive version
Both RIP Admin Mode RIP administrative mode of router RIP operation; enable acti-
Link State
Authentication Type
Default Metric
The following information will be invalid if the link state is down.
Bad Packets Received The number of RIP response packets received by the RIP process
Bad Routes Received
Updates Sent
10-30
show ip rip interface <slot/port>
Privileged EXEC and User EXEC
Valid slot and port number separated by forward slashes. This is a
configured value.
The IP source address used by the specified RIP interface. This is
a configured value.
The RIP version(s) used when sending updates on the specified
interface. The types are none, RIP-1, RIP-1c, RIP-2. This is a
configured value.
The RIP version(s) allowed when receiving updates from the
specified interface. The types are none, RIP-1, RIP-2, Both. This
is a configured value.
vates, disable de-activates it. This is a configured value.
Indicates whether the RIP interface is up or down. This is a con-
figured value.
The RIP Authentication Type for the specified interface. The
types are none, simple, and encrypt. This is a configured value.
A number which represents the metric used for default routes in
RIP updates originated on the specified interface. This is a con-
figured value.
which were subsequently discarded for any reason.
The number of routes contained in valid RIP packets that were
ignored for any reason.
The number of triggered RIP updates actually sent on this inter-
face.
202-10088-01, March 2005
Routing Commands