Bootpdhcprelay Enable; No Bootpdhcprelay Enable; Bootpdhcprelay Maxhopcount; No Bootpdhcprelay Maxhopcount - NETGEAR ProSafe FSM7328S User Manual
Layer 3 managed switch software
Hide thumbs
Also See for ProSafe FSM7328S:
- Administration manual (124 pages) ,
- Hardware installation manual (40 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
bootpdhcprelay enable
This command enables the forwarding of relay requests for BootP/DHCP Relay on the system.
Default
Format
Mode
no bootpdhcprelay enable
This command disables the forwarding of relay requests for BootP/DHCP Relay on the system.
Format
Mode
bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the
system. The <hops> parameter has a range of 1 to 16.
Default
Format
Mode
no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP
Relay on the system.
Format
Mode
bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay on the
system. When the BOOTP relay agent receives a BOOTREQUEST message, it MAY use the
seconds-since-client-began-booting field of the request as a factor in deciding whether to relay the
request or not. The parameter has a range of 0 to 100 seconds.
Default
10-16
disabled
bootpdhcprelay enable
Global Config
no bootpdhcprelay enable
Global Config
4
bootpdhcprelay maxhopcount <1-16>
Global Config
no bootpdhcprelay maxhopcount
Global Config
0
202-10088-01, March 2005
Routing Commands
Advertisement
Table of Contents
