User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format
Mode
no diffserv
This command sets the DiffServ operational mode to inactive. While disabled, the DiffServ
configuration is retained and can be changed, but it is not activated. When enabled, Diffserv
services are activated.
Format
Mode
Class Commands
The 'class' command set is used in DiffServ to define:
Traffic Classification
Service Levels
This set of commands consists of class creation/deletion and matching, with the class match
commands specifying layer 3, layer 2, and general match criteria. The class match criteria are also
known as class rules, with a class definition consisting of one or more rules to identify the traffic
belonging to the class. Note that once a class match criterion is created for a class, it cannot be
changed or deleted - the entire class must be deleted and re-created.
The CLI command root is
class-map
This command defines a new DiffServ class of type match-all, match-any or match-access-group.
The <classname> parameter is a case sensitive alphanumeric string from 1 to 31 characters
uniquely identifying the class (Note: the class name 'default' is reserved and must not be used
here).
When used without any match condition, this command enters the class-map mode. The
<classname> is the name of an existing DiffServ class (note: the class name 'default' is reserved
and is not allowed here)
Quality of Service (QoS) Commands
diffserv
Global Config
no diffserv
Global Config
Specify Behavior Aggregate (BA), based on DSCP, and Multi-
Field (MF) classes of traffic (name, match criteria)
Specify the BA forwarding classes / service levels. Conceptually,
DiffServ is a two-level hierarchy of classes: 1. Service/PHB, 2.
Traffic Class
.
class-map
202-10088-01, March 2005
11-9