Show Users - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Connection From
Idle Time
Session Time

show users

This command displays the configured user names and their settings. This command is only
available for users with Read/Write privileges.
available on the system.
Format
Mode
User Name
Access Mode
SNMPv3 Access Mode This field displays the SNMPv3 Access Mode. If the value is set
SNMPv3 Authentication This field displays the authentication protocol to be used for the
SNMPv3 Encryption
8-78
case sensitive. Two users are included as the factory default,
'admin' and 'guest'.
IP address of the telnet client machine or EIA-232 for the serial
port connection.
Time this session has been idle.
Total time this session has been connected.
The SNMPv3 fields will only be displayed if SNMP is
show users
Privileged EXEC
The name the user will use to login using the serial port, Telnet or
Web. A new user may be added to the switch by entering a name
in a blank entry. The user name may be up to eight characters, and
is not case sensitive. Two users are included as the factory
default, 'admin' and 'guest'
Shows whether the operator is able to change parameters on the
switch (Read/Write) or is only able to view them (Read Only). As
a factory default, the 'admin' user has Read/Write access and the
'guest' has Read Only access. There can only be one Read/Write
user and up to five Read Only users.
to the SNMPv3 user will be able to set and retrieve
ReadWrite,
parameters on the system. If the value is set to
SNMPv3 user will only be able to retrieve parameter information.
The SNMPv3 access mode may be different than the CLI and
Web access mode.
specified login user.
This field displays the encryption protocol to be used for the
specified login user.
202-10088-01, March 2005
the
ReadOnly,
Switching Commands