User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The expedite kbps and percent commands are alternative ways to specify the same expedite
policy attribute.
Format
Mode
Restrictions
Policy Type
Incompatibilities
mark cos
This command marks all packets for the associated traffic stream with the specified class of
service value in the priority field of the 802.1p header. If the packet does not already contain this
header, one is inserted. The CoS value is an integer from 0 to 7.
Default
Format
Mode
Policy Type
mark ip-dscp
This command marks all packets for the associated traffic stream with the specified IP DSCP
value.
The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through one of
the following keywords:
af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
Format
Mode
Quality of Service (QoS) Commands
expedite percent <1-100> [1-128]
Policy-classmap Config
The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Out
Bandwidth (all forms), Shape Peak
1
mark-cos <0-7>
Policy-classmap Config
In
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41,
mark ip-dscp <dscpval>
Policy-classmap Config
202-10088-01, March 2005
11-23