Bandwidth Percent; Class - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Incompatibilities

bandwidth percent

This command identifies a minimum amount of bandwidth to be reserved for the specified class
instance within the named policy using a relative rate notation. The committed information rate is
specified as a percentage of total link capacity and is an integer from 1 to 100.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The bandwidth kbps and percent commands are alternative ways to specify the same
bandwidth policy attribute.
Format
Mode
Restrictions
Policy Type
Incompatibilities

class

This command creates an instance of a class definition within the specified policy for the purpose
of defining treatment of the traffic class through subsequent policy attribute statements. The
< is the name of an existing DiffServ class. Note that this command causes the
classname>
specified policy to create a reference to the class definition.
Note: The CLI mode is changed to Policy-classmap Config when this command is successfully
executed.
Format
Mode
Quality of Service (QoS) Commands
Expedite (all forms)
bandwidth percent <1-100>
Policy-classmap Config
The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Out
Expedite (all forms)
class <classname>
Policy-Map Config
202-10088-01, March 2005
11-21