Match Dstip; Match Dstl4Port - NETGEAR ProSafe FSM7328S User Manual

Layer 3 managed switch software
Hide thumbs Also See for ProSafe FSM7328S:
Table of Contents

Advertisement

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

match dstip

This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The <ipaddr> parameter specifies an IP address. The <
specifies an IP address bit mask; note that although similar to a standard subnet mask, this bit mask
need not be contiguous. The optional [
condition for the class (i.e., match all destination IP addresses except for what is specified here).
Default
Format
Mode

match dstl4port

This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword or numeric notation or a numeric range notation.
To specify the match condition as a single keyword, the value for <
port name keywords. The currently supported <
smtp, snmp, telnet, tftp, www
both the start and end of a port range.
To specify the match condition using a numeric notation, one layer 4 port number is required. The
port number is an integer from 0 to 65535.
To specify the match condition using a numeric range notation, two layer 4 port numbers are
required and together they specify a contiguous port range. Each port number is an integer from 0
to 65535, but with the added requirement that the second number be equal to or greater than the
first.
The optional [not] parameter has the effect of negating this match condition for the class (i.e.,
match all destination layer 4 port numbers except for the one specified here).
Default
Format
Mode
11-14
parameter has the effect of negating this match
not]
none
match [not] dstip <ipaddr> <ipmask>
Class-Map Config
. Each of these translates into its equivalent port number, which is used as
none
match [not] dstl4port {portkey | <0-65535>} [0-65535]
Class-Map Config
202-10088-01, March 2005
portkey>
values are:
portkey>
domain, echo, ftp, ftpdata, http,
Quality of Service (QoS) Commands
parameter
ipmask>
is one of the supported

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fsm7352s7300s series

Table of Contents