User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
encapsulation
This command configures the link layer encapsulation type for the packet. Acceptable values for
<encapstype> are Ethernet and SNAP. The default is Ethernet.
Format
Mode
Restrictions
Bootp/DHCP Relay Commands
This chapter provides a detailed explanation of the BootP/DHCP Relay commands. The
commands are divided by functionality into the following different groups:
•
Show commands are used to display switch settings, statistics and other information.
•
Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
•
Copy commands are used to transfer configuration and informational files to and from the
switch.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default
Format
Mode
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format
Mode
Routing Commands
encapsulation {ethernet | snap}
Interface Config
Routed frames are always Ethernet encapsulated when a frame is
routed to a VLAN.
disabled
bootpdhcprelay cidoptmode
Global Config
no bootpdhcprelay cidoptmode
Global Config
202-10088-01, March 2005
10-15