Snmptrap; No Snmptrap; Snmptrap Ipaddr; Snmptrap Mode - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

snmptrap

This command adds an SNMP trap name. The maximum length of name is 16 case-sensitive
alphanumeric characters.
Default
Format
Mode

no snmptrap

This command deletes trap receivers for a community.
Format
Mode

snmptrap ipaddr

This command assigns an IP address to a specified community name. The maximum length of
name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries
using the same IP address, the first entry is retained and processed. All duplicate entries are
ignored.
Format
Mode

snmptrap mode

This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
Mode

no snmptrap mode

This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able to receive
traps).
8-34
The default name for the six undefined community names is
Delete.
snmptrap <name> <ipaddr>
Global Config
no snmptrap <name> <ipaddr>
Global Config
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Global Config
snmptrap mode <name> <ipaddr>
Global Config
202-10088-01, March 2005
Switching Commands