No Telnetcon Timeout; Serial Baudrate; No Serial Baudrate; Serial Timeout - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

no telnetcon timeout

This command sets the telnet connection session timeout value, in minutes, to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Format
Mode

serial baudrate

This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
Format
Mode

no serial baudrate

This command sets the communication rate of the terminal interface.
Format
Mode

serial timeout

This command specifies the maximum connect time (in minutes) without console activity. A value
of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
Default
Format
Mode

no serial timeout

This command sets the maximum connect time (in minutes) without console activity.
Format
8-22
no telnetcon timeout
Privileged EXEC
9600
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 |
38400 | 57600 | 115200}
Line Config
no serial baudrate
Line Config
5
serial timeout <0-160>
Line Config
no serial timeout
202-10088-01, March 2005
Switching Commands