User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
client-identifier
This command specifies the unique identifier for a DHCP client. Unique-identifier is a valid
notation in hexadecimal format. In some systems, such as Microsoft DHCP clients, the client
identifier is required instead of hardware addresses. The unique-identifier is a concatenation of the
media type and the MAC address. For example, the Microsoft client identifier for Ethernet address
c819.2488.f177 is 01c8.1924.88f1.77 where 01 represents the Ethernet media type. Refer to the
"Address Resolution Protocol Parameters" section of RFC 1700, Assigned Numbers for a list of
media type codes.
Default
Format
Mode
no client-identifier
This command deletes the client identifier.
Format
Mode
client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard
ASCII characters.
Default
Format
Mode
no client-name
This command removes the client name.
Format
Mode
8-82
None
client-identifier <uniqueidentifier>
DHCP Pool Config
no client-identifier
DHCP Pool Config
None
client-name <name>
DHCP Pool Config
no client-name
DHCP Pool Config
202-10088-01, March 2005
Switching Commands