Show Interface Ethernet - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Transmit Packets Errors The number of outbound packets that could not be transmitted
Collisions Frames
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-
The display parameters, when the argument is 'switchport', is as follows :
Packets Received Without Error The total number of packets (including broadcast pack-
Broadcast Packets Received The total number of packets received that were directed to
Packets Received With Error The number of inbound packets that contained errors pre-
Packets Transmitted Without Error The total number of packets transmitted out of the
Broadcast Packets Transmitted The total number of packets that higher-level protocols
Transmit Packet Errors The number of outbound packets that could not be transmitted
Address Entries Currently In Use The total number of Forwarding Database Address
VLAN Entries Currently In Use The number of VLAN entries presently occupying the
Time Since Counters Last Cleared The elapsed time, in days, hours, minutes, and sec-

show interface ethernet

This command displays detailed statistics for a specific port or for all CPU traffic based upon the
argument.
8-4
because of errors.
The best estimate of the total number of collisions on this Ether-
net segment.
onds since the statistics for this port were last cleared.
ets and multicast packets) received by the processor.
the broadcast address. Note that this does not include multicast
packets.
venting them from being deliverable to a higher-layer protocol.
interface.
requested to be transmitted to the Broadcast address, including
those that were discarded or not sent.
because of errors.
Table entries now active on the switch, including learned and
static entries.
VLAN table.
onds since the statistics for this switch were last cleared.
202-10088-01, March 2005
Switching Commands