Match Ip Tos; Match Protocol - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

match ip tos

This command adds to the specified class definition a match condition based on the value of the IP
TOS field in a packet, which is defined as all eight bits of the Service Type octet in the IP header.
The value of <
tosbits>
two-digit hexadecimal number from 00 to ff. The optional [
negating this match condition for the class (i.e., match all IP Precedence values except for what is
specified here). The <
against the IP TOS field in a packet. For example, to check for an IP TOS value having bits 7 and
5 set and bit 1 clear, where bit 7 is most significant, use a <
< of a2 (hex).
tosmask>
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a
match criterion for the same Service Type field in the IP header, but with a slightly different user
notation.
Note: In essence, this the "free form" version of the IP DSCP/Precedence/TOS match specification
in that the user has complete control of specifying which bits of the IP Service Type field are
checked.
Default
Format
Mode

match protocol

This command adds to the specified class definition a match condition based on the value of the IP
Protocol field in a packet using a single keyword notation or a numeric value notation.
To specify the match condition using a single keyword notation, the value for <
one of the supported protocol name keywords. The currently supported values are:
. Note that a value of ip is interpreted to match all protocol number values.
tcp, udp
To specify the match condition using a numeric value notation, the protocol number is a standard
value assigned by IANA and is interpreted as an integer from 0 to 255. Note: This command does
not validate the protocol number value against the current list defined by IANA.
The optional [ parameter has the effect of negating this match condition for the class (i.e.,
not]
match all IP Protocol numbers except for the one specified here).
Default
Format
11-16
is a two-digit hexadecimal number from 00 to ff. The value of <
denotes the bit positions in <
tosmask>
none
match [not] ip tos <tosbits> <tosmask>
Class-Map Config
none
match [not] protocol {protocol-name | <0-255>}
202-10088-01, March 2005
parameter has the effect of
not]
that are used for comparison
tosbits>
value of a0 (hex) and a
tosbits>
protocol-name>
Quality of Service (QoS) Commands
is a
tosmask>
is
icmp, igmp, ip,