Quick Start Up Uploading From Switch To Out-Of-Band Pc (Only Xmodem) - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Table 6-5. Quick Start-up IP Address Using Switch as Layer-3 Device
Command
# vlan data base
(vlan) # vlan routing 1
(vlan) # exit
# config
(config) # ip routing
(config) # interface 0/2/1
(config) # ip address <ip addr> <netmask>
(config) # exit
Quick Start up Uploading from Switch to Out-of-Band PC (Only
XMODEM)
Table 6-6. Quick Start up Uploading from Switch to Out-of-Band PC (XMODEM)
Command
copy {
nvram:startup-config |
nvram:errorlog |
nvram:msglog |
nvram:traplog} <url>
Quick Start up
Details
Enter VLAN configuration mode
Enable VLAN routing interface, "0/2/1" created
Exit from VLAN configuration mode
Enter global configuration mode
Enable global IP routing mode
Enter interface configuration mode
Enter desired IP address and netmask
Exit from global configuration mode
Details
The types are:
config - configuration file
errorlog - error log
system trace - system trace
traplog - trap log
The URL must be specified as:
xmodem:filepath/fileName
This starts the upload and also displays the mode of
uploading and the type of upload it is and confirms the
upload is taking place.
For example:
If the user is using HyperTerminal, the user must
specify where the file is going to be received by the
PC.
202-10088-01, March 2005
6-5