Users Snmpv3 Encryption; No Users Snmpv3 Encryption; Dhcp Server Commands - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

users snmpv3 encryption

This command specifies the encryption protocol to be used for the specified login user. The valid
encryption protocols are des or
If des is specified, the required key may be specified on the command line. The encryption
must be 8 to 64 characters long. If the
will be prompted for the key. When using the des protocol, the user login password is also used as
the snmpv3 encryption password and therefore must be at least eight characters in length.
If is specified, a key must not be provided. The <
none
associated with the specified encryption.
Default
Format
Mode

no users snmpv3 encryption

This command sets the encryption protocol to none. The <username> is the login user name for
which the specified encryption protocol will be used.
Format
Mode

DHCP Server Commands

These commands configure the DHCP Server parameters and address pools. The commands are
divided by functionality into these different groups:
• Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
• Show commands are used to display switch settings, statistics and other information.
• Clear commands clear some or all of the settings to factory defaults.
Switching Commands
none.
protocol is specified but a key is not provided, the user
des
no encryption
users snmpv3 encryption <username> <none | des[key]>
Global Config
no users snmpv3 encryption <username>
Global Config
202-10088-01, March 2005
is the login user name
username>
key
8-81