User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to enabled.
Default
Format
Mode
no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
Format
Mode
spanning-tree
This command sets the STP mode for a specific port-channel (LAG). This is the value specified
for STP Mode on the Port Configuration Menu. 802.1D mode is the default. The interface is a
logical slot/port for a configured port-channel. The
(LAGs) with the same option.
Format
Mode
The mode is one of the following:
802.1d
fast
off
spanning-tree bpdumigrationcheck
This command enables BPDU migration check on a given interface. The all option enables BPDU
migration check on all interfaces.
Format
Mode
8-126
disabled
spanning-tree port mode all
Global Config
no spanning-tree port mode all
Global Config
all
spanning-tree {<logical slot/port> | all | <off |
802.1d | fast>}
Global Config
IEEE 802.1D-compliant STP mode is used
Fast STP mode is used
STP is turned off
spanning-tree bpdumigrationcheck {<slot/port> | all}
Global Config
202-10088-01, March 2005
option sets all configured port-channels
Switching Commands