Show Port Protocol - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format
Mode
Slot/Port
Type
Admin Mode
Physical Mode
Physical Status
Link Status
Link Trap
LACP Mode

show port protocol

This command displays the Protocol-Based VLAN information for either the entire system, or for
the indicated Group.
Format
Mode
Group Name
Group ID
Protocol(s)
Switching Commands
show port {<slot/port> | all}
Privileged EXEC
Valid slot and port number separated by forward slashes.
If not blank, this field indicates that this port is a special type of
port. The possible values are:
Mon - this port is a monitoring port. Look at the Port Monitoring
screens to find out more information.
Lag - this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Selects the Port control administration state. The port must be
enabled in order for it to be allowed into the network. - May be
enabled or disabled. The factory default is enabled.
Selects the desired port speed and duplex mode. If auto-negotia-
tion support is selected, then the duplex mode and speed will be
set from the auto-negotiation process. Note that the port's maxi-
mum capability (full duplex -100M) will be advertised. Other-
wise, this object will determine the port's duplex mode and
transmission rate. The factory default is Auto.
Indicates the port speed and duplex mode.
Indicates whether the Link is up or down.
This object determines whether or not to send a trap when link
status changes. The factory default is enabled.
Displays whether LACP is enabled or disabled on this port.
show port protocol <groupid | all>
Privileged EXEC
This field displays the group name of an entry in the Protocol-based VLAN
table.
This field displays the group identifier of the protocol group.
This field indicates the type of protocol(s) for this group.
202-10088-01, March 2005
8-47