User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
transport output telnet
This command regulates new outbound telnet connections. If enabled, new outbound telnet
sessions can be established until it reaches the maximum number of simultaneous outbound telnet
sessions allowed. If disabled, no new outbound telnet session can be established. An established
session remains active until the session is ended or an abnormal network error ends it.
Default
Format
Mode
no transport output telnet
This command disables new outbound telnet connections. If disabled, no new outbound telnet
connection can be established.
Format
Mode
session-limit
This command specifies the maximum number of simultaneous outbound telnet sessions. A value
of 0 indicates that no outbound telnet session can be established.
Default
Format
Mode
Line Config
no session-limit
This command sets the maximum number of simultaneous outbound telnet sessions to the default
value.
Format
Mode
session-timeout
This command sets the outbound telnet session timeout value.The timeout value unit of time is
minutes. A value of 0 indicates that a session remains active indefinitely.
Switching Commands
enabled
transport output telnet
Line Config
no transport output telnet
Line Config
5
session-limit <0-5>
no session-limit
Line Config
202-10088-01, March 2005
8-17