Show Logging; Show Mac-Addr-Table - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

show logging

This command displays the trap log maintained by the switch. The trap log contains a maximum of
256 entries that wrap.
Format
Mode
Number of Traps since last reset The number of traps that have occurred since the last
Number of Traps since log last displayed The number of traps that have occurred
Log
System Up Time
Trap
Note:

show mac-addr-table

This command displays the forwarding database entries. If the command is entered with no
parameter, the entire table is displayed. This is the same as entering the optional
Alternatively, the administrator can enter a MAC Address to display the table entry for the
requested MAC address and all entries following the requested MAC address.
Format
Mode
Mac Address
A unicast MAC address for which the switch has forwarding and or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that are separated by colons,
for example 01:23:45:67:89:AB. In an IVL system the MAC address will be displayed as 8
bytes.
Slot/Port
if Index
Status
Switching Commands
show logging
Privileged EXEC
reset of this device.
since the traps were last displayed. Getting the traps by any
method (terminal interface display, Web display, upload file from
switch etc.) will result in this counter being cleared to 0.
The sequence number of this trap.
The relative time since the last reboot of the switch at which this
trap occurred.
The relevant information of this trap.
Trap log information is not retained across a switch reset.
show mac-addr-table [<macaddr> | all]
Privileged EXEC
The port which this address was learned.
This object indicates the ifIndex of the interface table entry asso-
ciated with this port.
The status of this entry. The meanings of the values are:
202-10088-01, March 2005
parameter.
all
8-13