Internet Group Management Protocol (Igmp) Commands; Set Igmp; No Set Igmp - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Mode
Mac Address
Type
Description
Interfaces

Internet Group Management Protocol (IGMP) Commands

This chapter provides a detailed explanation of the IGMP commands. The commands are divided
into two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.

set igmp

This command enables IGMP Snooping on the system. The default value is disable.
Note:
The IGMP application supports the following:
• Global configuration or per interface configuration. Per VLAN configuration is unsupported
in the IGMP snooping application.
• Validation of the IP header checksum (as well as the IGMP header checksum) and discarding
of the frame upon checksum error.
• Maintenance of the forwarding table entries based on the MAC address versus the IP address.
• Flooding of unregistered multicast data packets to all ports in the VLAN.
Format
Mode
Switching Commands
Privileged EXEC
A unicast MAC address for which the switch has forwarding and or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that are sepa-
rated by colons, for example 01:23:45:67:89:AB. In an IVL system the MAC
address will be displayed as 8 bytes.
This displays the type of the entry. Static entries are those that are configured by
the end user. Dynamic entries are added to the table as a result of a learning pro-
cess or protocol.
The text description of this multicast table entry.
The list of interfaces that are designated for forwarding (Fwd:) and filtering
(Flt:).
set igmp
Global Config
202-10088-01, March 2005
8-105