No Macfilter Addsrc; Macfilter Addsrc All; No Macfilter Addsrc All; Monitor Session - NETGEAR ProSafe FSM7328S User Manual
Layer 3 managed switch software
Hide thumbs
Also See for ProSafe FSM7328S:
- Administration manual (124 pages) ,
- Hardware installation manual (40 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Mode
no macfilter addsrc
This command removes a port from the source filter set for the MAC filter with the MAC address
of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
Mode
macfilter addsrc all
This command adds all interfaces to the source filter set for the MAC filter with the MAC addressf
<macaddr> and <vlanid>. The <macaddr> parameter must be specified as a 6-byte hexadecimal
number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must identify a valid VLAN.
Format
Mode
no macfilter addsrc all
This command removes all interfaces to the source filter set for the MAC filter with the MAC
address of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a
6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
Mode
monitor session
This command configures a probe port and a monitored port for monitor session (port monitoring).
The first slot/port is the source monitored port and the second slot/port is the destination probe
port. If this command is executed while port monitoring is enabled, it will have the effect of
changing the probe and monitored port values.
8-40
Interface Config
no macfilter addsrc <macaddr> <vlanid>
Interface Config
macfilter addsrc {all | <macaddr> <vlanid> }
Global Config
no macfilter addsrc {all | <macaddr> <vlanid> }
Global Config
202-10088-01, March 2005
Switching Commands
Advertisement
Table of Contents
