No Default-Information Originate (Rip); Default-Metric (Rip); No Default-Metric (Rip); No Distance Rip - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format
Mode

no default-information originate (RIP)

This command is used to control the advertisement of default routes.
Format
Mode

default-metric (RIP)

This command is used to set a default for the metric of distributed routes.
Format
Mode

no default-metric (RIP)

This command is used to reset the default metric of distributed routes to its default value.
Format
Mode
distance rip
This command sets the route preference value of RIP in the router. Lower route preference values
are preferred when determining the best route.
Default
Format
Mode

no distance rip

This command sets the default route preference value of RIP in the router.
Format
Mode
10-24
default-information originate
Router RIP Config
no default-information originate
Router RIP Config
default-metric <0-15>
Router RIP Config
no default-metric
Router RIP Config
15
distance rip <0-255>
Router RIP Config
no distance rip
Router RIP Config
202-10088-01, March 2005
Routing Commands