Qos Egress Port Tag Remarking - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Queue Scheduler Controls the weight for this queue. The default value is "17". This value
Weight is restricted to 1-100. This parameter is only shown if "Scheduler Mode"
is set to "Weighted".
Queue Scheduler Shows the weight in percent for this queue. This parameter is only
Percent shown if "Scheduler Mode" is set to "Weighted".
Port Shaper Enable Controls whether the port shaper is enabled for this switch port.
Port Shaper Rate Controls the rate for the port shaper. The default value is 500. This value
is restricted to
restricted to 1-
Port Shaper Unit Controls the unit of measure for the port shaper rate as "kbps" or
"Mbps". The default value is "kbps".
Port Shaper Rate- The rate type of the port shaper. The allowed values are:
•
type
•

QoS Egress Port Tag Remarking

This section provides an overview of QoS Egress Port Tag Remarking for all switch ports.
Web GUI: Configuration > QoS > Port Tag Remarking
Figure 4-54: QoS Egress Port Tag Remarking
By clicking on any port, you may configure the selected port (see example for port 6).
Figure 4-55: QoS Egress Port Tag Remarking
81
-1000000 when the "Unit" is "kbps", and it is
100
when the "Unit" is "Mbps".
3300
Line: Specify that this shaper operates on line rate.
Data: Specify that this shaper operates on data rate.