FibroLAN Falcon-RX/812/G/A User Manual page 143

Falcon R-Class | User Guide
Adding a New Server
Click Add New Server to add a new RADIUS server. An empty row is added to the table, and the
RADIUS server can be configured as needed. Up to
The Delete button can be used to undo the addition of the new server.
4.8.4.2 Radius Server Status Overview
This page provides an overview of the status of the RADIUS servers configurable on the Global and
Server configurations
Web GUI: Monitor > Security > AAA > RADIUS Overview
Figure 4-90: RADIUS: Server Status Overview
Table 4-86: RADIUS: Server Status Overview parameters
RADIUS Servers
#The RADIUS server number. Click to navigate to detailed statistics for this server.
IP Address The IP address of the server
Authentication UDP port number for authentication
Port
The current status of the server. This field takes one of the following values:
•
•
•
Authentication
Status
•
Accounting Port UDP port for accounting
The status of the server. This field takes one of the following values:
Accounting
•
Status
143
Disabled: The server is disabled.
Not Ready: The server is enabled, but IP communication is not yet up
and running.
Ready: The server is enabled, IP communication is up and running, and
the RADIUS module is ready to accept access attempts.
Dead (X seconds left): Access attempts were made to this server, but it
did not reply within the configured timeout. The server has temporarily
been disabled but will get re-enabled when the dead-time expires. The
number of seconds left before this occurs is displayed in parentheses.
This state is only reachable when more than one server is enabled.
Disabled: The server is disabled.
servers are supported.
5