Ptp Clock's Configuration And Status - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide

PTP Clock's Configuration and Status

This page allows the user to inspect and configure the current PTP clock settings. It contains the
following configuration and status tables:
Web GUI: Configuration > Timing > PTP > (Hit Clock Inst. Number)
4.12.2.1 Clock Type and Profile
Figure 4-114: Clock Type and Profile
Table 4-108: Clock Type and Profile
Clock Instance Indicates the Instance of a particular Clock Instance [0...3].
HW Domain Indicates the HW clock domain used by the clock.
Device Type Indicates the Type of the Clock Instance. There are five Device Types.
Profile Indicates the profile used by the clock.
Apply Profile If the clock has been configured to use a profile, clicking the 'Apply' button
Defaults will reset configured values to profile defaults.
4.12.2.2 Port Enable and Configuration
Figure 4-115: Port Enable and Configuration
Table 4-109: Port Enable and Configuration
Port Enable Set check mark for each port configured for this Clock Instance.
Configuration Click 'Ports Configuration' to edit the port data set for the ports assigned to
this clock instance.
4.12.2.3 Local Clock Current Time
Figure 4-116: Local Clock Current time
Table 4-110: Local Clock Current time
167
1. Ord-Bound – clock's Device Type is Ordinary-Boundary Clock.
2. P2p Transp – clock's Device Type is Peer to Peer Transparent Clock.
3. E2e Transp – clock's Device Type is End to End Transparent Clock.
4. Master Only – clock's Device Type is Master Only.
5. Slave Only – clock's Device Type is Slave Only.