Mac Learning Table; Configuring The Mac Address Table - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide

4.5 MAC Learning Table

This section details the MAC Learn Table functionality.
Switching of frames is based upon the DMAC address contained in the frame. The switch builds up a
table that maps MAC addresses to switch ports for knowing which ports the frames should be
delivered to (Based upon the DMAC address in the frame). This table contains both static and
dynamic entries. The static entries are configured by the network administrator if the administrator
wants to do a fixed mapping between the DMAC address and switch ports.
The frames also contain a MAC address (SMAC address), which shows the MAC address of the
equipment sending the frame. The SMAC address is used by the switch to automatically update the
MAC table with these dynamic MAC addresses. Dynamic entries are removed from the MAC table if
no frame with the corresponding SMAC address has been seen after a configurable age time.
The R Class series MAC address space is up to 8K addresses.

Configuring the MAC Address Table

The MAC Address Table is configured on this section. Set timeouts for entries in the dynamic MAC
Table and configure the static MAC table
By default, the R Class series is configured for automatic learning on all ports. The table is sorted first
by VLAN ID, then by MAC address.
Timeouts are set for entries in the dynamic MAC address and Configuration is performed in the static
MAC table.
Web GUI: Configuration > MAC Table
Figure 4-23: MAC Address Table Configuration displays
41