FibroLAN Falcon-RX/812/G/A User Manual page 135

Falcon R-Class | User Guide
Max Dynamic Clients Specify the maximum number of dynamic clients that can be learned on
Buttons
4.8.2.13 Static IP Source Guard Table
Web GUI: Configuration > Security > Network > IP Source Guard/Static Table
Figure 4-83: Static IP Source Guard Table
Table 4-79: IP Source Guard Table Parameters
Delete Check to delete the entry. It will be deleted during the next save.
Port The logical port for the settings.
VLAN ID The VLAN ID for the settings.
IP Address Allowed Source IP address
MAC address Allowed Source MAC address
Buttons Add New Entry: Click to add a new entry to the Static IP Source Guard
table.
4.8.2.14 Dynamic IP Source Guard Table
Entries in the Dynamic IP Source Guard Table are shown on this page. The Dynamic IP Source Guard
Table is sorted first by port, then by VLAN ID, then by IP address, and then by MAC address
Navigating the IP Source Guard Table
Each page shows up to 99 entries from the Dynamic IP Source Guard table, default being 20, selected
through the "entries per page" input field. When first visited, the web page will show the first 20
entries from the beginning of the Dynamic IP Source Guard Table.
The "Start from port address", "VLAN" and "IP address" input fields allow the user to select the
starting point in the Dynamic IP Source Guard Table.
Clicking the Refresh button will update the displayed table starting from that or the closest next
Dynamic IP Source Guard Table match. In addition, the two input fields will - upon a Refresh button
click - assume the value of the first displayed entry, allowing for continuous refresh with the same
start address.
135
given port. This value can be 0, 1, 2 or unlimited. If the port mode is
enabled and the value of max dynamic client is equal to 0, it means only
allow the IP packets forwarding that are matched in static entries on the
specific port.
Translate dynamic to static: Click to translate all dynamic entries to
static entries.