Power Supply Overview; Ac Power Supply - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Web GUI: Maintenance > Configuration > Delete
Figure 7-9: Delete Configuration

7.5 Power Supply Overview

Warning
ONLY the Fibrolan Power Supply (AC or DC) is suitable to be used with the R
Class series unit.
Any other PS module (Fibrolan products or other), even if mechanically
matching, may cause irreversible damage to the system.
IN SUCH CASES THIS WILL VOID ANY WARRANTY!
Warning
NEVER OPEN THE DEVICE WHEN IT IS CONNECTED TO POWER LINES!
Caution
When connecting a device to an AC (DC) power outlet, always:
1.
(ensure that it is securely fastened).
2.
plugged into the wall outlet. Make sure to use grounded (3 way) outlets (for
AC models).
Note: For most countries Fibrolan ships an appropriate power supply cord which is safety approved
in accordance with the country's National Electric Code.
For certain countries Products are shipped without power cords. In such cases, locally purchased
safety approved power cords (in accordance with that country's National Electric Code) may be
used.

AC Power Supply

Connect AC line voltage using the power supply cords provided (alternatively you may use other
18AWG three wire cord). R Class devices will accept any line voltage from 100 to 240 VAC, 50-60 Hz.
There is no ON/OFF switch on the device. When the power is connected to the device, the device is
ON. This will be indicated by the Power (PWR) LED lit green on the front panel. The PS is rated for
ambient temperature of: -10°C ÷ +50°C.
306
First connect the
Only after connecting the power cord to the device, it should be
power cord to the device