Trap Source Configurations; Snmpv3 Community Configuration - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Switch Indicates that the Switch group's traps. Possible traps are:
•
•

Trap Source Configurations

This page provides SNMP trap source configurations. A trap is sent for the given trap source if at least
one filter with filter type included matches the filter, and no filters with filter type excluded matches.
Web GUI: Configuration > SNMP > Trap > Source
Figure 5-21: SNMP Trap Source Configuration display
Table 5-20: SNMP Trap Source Configuration Parameters
Delete Check to delete the entry. It will be deleted during the next save.
Name Indicates the name for the entry.
Type The filter type for the entry. Possible types are:
•
•
Subset OID The subset OID for the entry. The value should depend on what kind of trap name.
For example, the ifIdex is the subset OID of linkUp and linkDown. A valid subset
OID is one or more digital number (0-4294967295) or asterisk (*) which are
separated by dots(.). The first character must not begin with asterisk (*) and the
maximum of OID count must not exceed 128

SNMPv3 Community Configuration

Configure SNMPv3 community table. The entry index key is "Community".
Web GUI: Configuration > SNMP > Communities
Figure 5-22: SNMPv3 Community Configuration
278
STP: Enable/disable STP trap.
RMON: Enable/disable RMON trap.
v
Included: An optional flag to indicate a trap is sent for the given trap source is
matched.
Excluded: An optional flag to indicate a trap is not sent for the given trap
source is matched.