FibroLAN Falcon-RX/812/G/A User Manual page 139

Falcon R-Class | User Guide
Table 4-82: VLAN Mode Configuration Parameters
VLAN Mode Configuration
Specify ARP Inspection is enabled on which VLANs. First, you must enable the port setting on
Port mode configuration web page. Only when both Global Mode and Port Mode on a given port
are enabled, ARP Inspection is enabled on this given port. Second, you can specify which VLAN
will be inspected on VLAN mode configuration web page. The log type also can be configured on
per VLAN setting.
Possible types are:
•
None: Log nothing.
•
Deny: Log denied entries.
•
Permit: Log permitted entries.
•
All: Log all entries
Buttons Add New Entry: Click to add a new VLAN to the ARP Inspection VLAN table.
Navigating the VLAN Configuration
Each page shows up to 9999 entries from the VLAN table, default being 20, selected through the
"entries per page" input field. When first visited, the web page will show the first 20 entries from
the beginning of the VLAN Table. The first displayed will be the one with the lowest VLAN ID
found in the VLAN Table. The "VLAN" input fields allow the user to select the starting point in
the VLAN Table.
Clicking Refresh the button will update the displayed table starting from that or the closest next
VLAN Table match. The >> will use the next entry of the currently displayed VLAN entry as a basis
for the next lookup. When the end is reached the warning, message is shown in the displayed
table. Use the << button to start over.
4.8.3.3 Static ARP Inspection Table
This page shows the static ARP Inspection rules. The maximum number of rules is 256 on the switch.
Web GUI: Monitor > Security > Network > ARP Inspection > Static Table
Figure 4-87: Static ARP Inspection Table display
Table 4-83: Static ARP Inspection Table parameters
Static ARP Inspection Table
Delete Check to delete the entry. It will be deleted during the next save
Port The logical port for the settings.
VLAN ID The VLAN ID for the settings.
139