Qos Ingress Port Policers - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Ingress Map Controls the
from 0 to 255. An empty field indicates no map selection.
Egress Map Controls the
from 0 to 511. An empty field indicates no map selection.

QoS Ingress Port Policers

This section allows you to configure the
A policer can limit the bandwidth of received frames. It is in front of the ingress queue.
Web GUI: Configuration > QoS > Port Policing
Figure 4-48: QoS Ingress Port Policers
Table 4-45: QoS Ingress Port Policers Parameters
Port The port number for which the configuration below applies.
Enable Controls whether the policer is enabled on this switch port.
Rate Controls the rate for the policer. The default value is 500. This value is
restricted to
1-
3300
Unit Controls the unit of measure for the policer rate as kbps, Mbps, fps or KFPS.
The default value is kbps.
Flow Control If flow control is enabled and the port is in flow control mode, then pause
frames are sent instead of discarding frames.
75
Ingress Map selection through the Map ID. The Ingress Map ID ranges
Egress Map selection through the Map ID. The Egress Map ID ranges
settings for all switch ports.
Policer
-1000000 when the Unit is kbps or fps, and it is restricted to
100
when the Unit is Mbps or KFPS.