Sflow Statistics - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Port Configuration
Port
Flow Sampler Enabled
Flow Sampler Sampling
Rate:
Flow Sampler Max.
Header
Counter Poller Enabled
Counter Poller Interval

sFlow Statistics

This sub-section shows receiver and per-port
Web GUI: Monitor > sFlow
Figure 4-182: sFlow Statistics displays
253
The port number for which the configuration below applies.
Enables/disables flow sampling on this port.
The statistical sampling rate for packet sampling. Set to N to sample
on average 1/Nth of the packets transmitted/received on the port.
Not all sampling rates are achievable. If an unsupported sampling rate
is requested, the switch will automatically adjust it to the closest
achievable. This will be reported back in this field. Valid range is 1 to
32767.
The maximum number of bytes that should be copied from a sampled
packet to the sFlow datagram. Valid range is 14 to 200 bytes with
default being 128 bytes.
To have room for any frame, the maximum datagram size should be
roughly 100 bytes larger than the maximum header size. If the
maximum datagram size does not consider the maximum header size,
samples may be dropped.
Enables/disables counter polling on this port.
With counter polling enabled, this specifies the interval - in seconds -
between counter poller samples. Valid range is 1 to 3600 seconds.
statistics.
sFlow