Falcon R-Class | User Guide
3
Getting Started
3.1 Quick Setup Outline
To set up the R Class models carry out the following steps:
Mount the device at its location (rack or desktop).
1
Install the SFP transceivers.
2
Connect the unit to a console and a power source (Figure 3-1).
3
Verify that the Power (PS1, PS2 or both) LEDs are green lit.
4
Connect required cables to ports: twisted pair (RJ45 Ethernet) and fiber (Ethernet SFPs).
5
Verify that the ports Link and Speed LEDs are lit per connected interfaces.
6
Configure the selected device via the console to assign management IP address or use default IP
7
address (192.168.1.90)
Establish management access via SSH, Telnet or Web GUI (4.1.2).
8
For a general configuration procedure please refer to the Getting Started Quick Guide located at
9
www.Fibrolan.com (Resources > Documents > Quick Guides).
Note: Remote management requires basic IP configuration.
14