Ip Routes; Ntp Configuration - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide

IP Routes

Web GUI: Configuration > System > IP
Figure 4-5: IP Routes
Table 4-4: IP Routes Parameters
Delete
Network
Mask Length
Gateway
Distance (Only for IPv4)
Next Hop VLAN (Only for
IPv6)
Buttons

NTP Configuration

NTP is an acronym for Network Time Protocol, a network protocol for synchronizing the clocks of
computer systems. NTP uses UDP (datagrams) as transport layer. The Falcon-RX supports both client
and server functions of the protocol.
Figure 4-6: System Time Display
23
Select this option to delete an existing IP route.
The destination IP network or host address of this route. Valid format
is dotted decimal notation or a valid IPv6 notation. A default route can
use the value 0.0.0.0or IPv6:: notation.
The destination IP network or host mask, in number of bits (prefix
length). It defines how much of a network address that must match, in
order to qualify for this route. Valid values are between 0 and 32 bits
respectively 128 for IPv6 routes. Only a default route will have a mask
length of 0 (as it will match anything).
The IP address of the IP gateway. Valid format is dotted decimal
notation for a valid IPv6 notation. Gateway and Network must be of
the same type.
The distance value of route entry is used to provide the priority
information of the routing protocols to routers. When there are two or
more different routing protocols are involved and have the same
destination, the distance value can be used to select the best path.
The VLAN ID (VID) of the specific IPv6 interface associated with the
gateway. The given VID ranges from 1 to 4095 and will be effective only
when the corresponding IPv6 interface is valid. If the IPv6 gateway
address is link-local, it must specify the next hop VLAN for the gateway.
If the IPv6 gateway address is not link-local, system ignores the next
hop VLAN for the gateway.
Add Route Click to add a new IP route. A maximum of
supported.
routes is
32