Dhcp Server Excluded Ip Configuration - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Table 5-7: DHCP Server Mode Configuration Parameters
Global Mode
Configure operation mode to enable/disable DHCP server per system.
Configure the operation mode per system. Possible modes are:.
Enabled
Disabled
VLAN Mode
Configure operation mode to enable/disable DHCP server per VLAN.
VLAN Range
Indicate the VLAN range in which DHCP server is enabled or disabled. The first VLAN ID must be
smaller than or equal to the second VLAN ID. BUT, if the VLAN range contains only 1 VLAN ID,
then you can just input it into either one of the first and second VLAN ID or both. On the other
hand, if you want to disable existed VLAN range, then you can follow the steps:
1. Press Add VLAN Range to add a new VLAN range
2. Input the VLAN range that you want to disable
3. Choose Mode to be Disabled.
4. Press Save to apply the change
Then, you will see the disabled VLAN range is removed from the DHCP Server mode configuration
page.
Mode
Indicate the operation mode per VLAN. Possible modes are:
Enabled
Disabled
Buttons

DHCP Server Excluded IP Configuration

This section configures excluded IP addresses. DHCP server will not allocate these excluded IP
addresses to DHCP client.
Web GUI: Configuration > DHCP > Server > Excluded IP
Figure 5-9:
DHCP Server Excluded IP Configuration
264
Enable DHCP server per system.
Disable DHCP server pre system
Enable DHCP server per VLAN.
Disable DHCP server pre VLAN.
Add VLAN Range: Click to add a new VLAN range.