Trap Configuration - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide

Trap Configuration

Configure the SNMP trap on this section.
Web GUI: Configuration > SNMP > System
Figure 5-20: SNMP Trap Configuration display
Table 5-19: SNMP Trap Configuration Parameters
SNMP Trap Detailed Configuration
Config Name Indicates which trap Configuration's name for configuring. The allowed string
length is 1 to 32, and the allowed content is ASCII characters from 33 to 126.
Mode Indicate the SNMP trap mode operation. Possible modes are:
•
•
Version Indicate the SNMP trap version. Possible versions are:
•
•
•
Community Indicates the community access string when sending SNMP trap packet. The
allowed string length is 0 to 63, and the allowed content is ASCII characters from
33 to 126.
276
Enabled: Enable SNMP trap mode operation.
Disabled: Disable SNMP trap mode operation.
SNMP v1: Set SNMP trap supported version 1.
SNMP v2c: Set SNMP supported version 2c.
SNMP v3: Set SNMP trap supported version 3.