FibroLAN Falcon-RX/812/G/A User Manual page 67

Falcon R-Class | User Guide
Table 4-38: MVR Configuration parameters
MVR Mode Enable/Disable the Global MVR. The Unregistered Flooding control depends
on the current configuration in IGMP/MLD Snooping. It is suggested to enable
Unregistered Flooding control when the MVR group table is full.
4.6.8.2 VLAN Interface Setting
Web GUI: Configuration > MVR
Figure 4-42: VLAN Interface Setting display
Table 4-39: VLAN Interface Setting parameters
VLAN Interface Setting
Delete
MVR VID
MVR Name
IGMP Address
Mode
Tagging
Priority
LLQI
67
Check to delete the entry. The designated entry will be deleted during
the next save.
Specify the Multicast VLAN ID.
Be Caution: MVR source ports are not recommended to be overlapped
with management VLAN ports.
MVR Name is an optional attribute to indicate the name of the specific
MVR VLAN. Maximum length of the MVR VLAN Name string is 16. MVR
VLAN Name can only contain alphabets or numbers. When the optional
MVR VLAN name is given, it should contain at least one alphabet. MVR
VLAN name can be edited for the existing MVR VLAN entries, or it can
be added to the new entries.
Define the IPv4 address as source address used in IP header for IGMP
control frames. The default IGMP address is not set (0.0.0.0). When the
IGMP address is not set, system uses IPv4 management address of the
IP interface associated with this VLAN. When the IPv4 management
address is not set, system uses the first available IPv4 management
address.
Specify the MVR mode of operation. In Dynamic mode, MVR allows
dynamic MVR membership reports on source ports. In Compatible
mode, MVR membership reports are forbidden on source ports. The
default is Dynamic mode.
Specify whether the traversed IGMP/MLD control frames will be sent
as Untagged or Tagged with MVR VID. The default is Tagged.
Specify how the traversed IGMP/MLD control frames will be sent in
prioritized manner. The default Priority is 0.
Define the maximum time to wait for IGMP/MLD report memberships
on a receiver port before removing the port from multicast group