Detailed Link Oam Link Events Status For Selected Port - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Table 4-164: Detailed Link OAM Status for selected port Parameters
Local and Peer
Mode
Unidirectional
Operation Support
Remote Loopback
Support
Link Monitoring
Support
MIB Retrieval
Support
MTU Size
Multiplexer State
Parser State
Organizational
Unique
Identification
PDU Revision
PDU Permission
Discovery State

Detailed Link OAM Link Events Status for selected port

This section allows the user to inspect the current Link OAM Link Event configurations and change
them as well. The left pane displays the Event status for the Local OAM unit while the right pane
displays the status for the Peer for the respective port.
240
The Mode in which the Link OAM is operating, Active or Passive.
This feature is not available to be configured by the user. The status of
this configuration is retrieved from the PHY.
If status is enabled, DTE is capable of OAM remote loopback mode.
If status is enabled, DTE supports interpreting Link Events.
If status ie enabled DTE supports sending Variable Response OAMPDUs.
It represents the largest OAMPDU, in octets, supported by the DTE. This
value is compared to the remotes Maximum PDU Size and the smaller of
the two is used.
When in forwarding state, the Device is forwarding non-OAMPDUs to
the lower sublayer. In case of discarding, the device discards all the non-
OAMPDU's.
When in forwarding state, Device is forwarding non-OAMPDUs to higher
sublayer. When in loopback, Device is looping back non-OAMPDUs to
the lower sublayer. When in discarding state, Device is discarding non-
OAMPDUs.
24-bit Organizationally Unique Identifier of the vendor.
It indicates the current revision of the Information TLV. The value of this
field shall start at zero and be incremented each time something in the
Information TLV changes.
This field is available only for the Local DTE. It displays the current
permission rules set for the local DTE. Possible values are "Link fault",
"Receive only", "Information exchange only", "ANY".
Displays the current state of the discovery process. Possible states are
Fault state, Active state, Passive state, SEND_LOCAL_REMOTE_STATE,
SEND_LOCAL_REMOTE_OK_STATE, SEND_ANY_STATE.