Console Connection And Configuration; Initial Ip Address Settings - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide

3.2 Console Connection and Configuration

Note: Applicable to R Class series devices.
Figure 3-1: Falcon console connection
To enable basic console connection for initial setup, carry out the following steps:
1. Use an RJ-45-to-DB-9 console cable and insert the RJ-45 connector into the console port on
the front panel. Alternately connect USB-to-USB from PC directly to USB port on Falcon front
panel. Configure the baud rate and character format of the PC or terminal to match these
console port default characteristics:
115200 baud, 8 data bits, 1 stop bit, No parity, None (flow control).
2. Connect the device to a power source and wait until it boots up.
3. The system prompts you to log in.
Default username: moose
Note: if you experiment
(International: support@Fibrolan.com; North America: Us-info@Fibrolan.com)

Initial IP address settings

This first configuration is done via the console; it enables the switch to connect to the IP network.
Once the unit IP address is set via console, the system can be accessed through Web, Telnet, SSH or
any other management options.
Initial IP setup can be implemented by manually setting the IP address Parameters or by an automatic
DHCP setup (if a DHCP server is present).
To assign a new IP address to the device enter the following CLI commands:
➢ configure terminal
➢ interface vlan 1
➢ ip address 192.168.1.90 255.255.255.0
The Falcon R class will initially boot-up with this default IP address: 192.168.1.90/24.
15
Default password: 1234.
difficulty in the connection, contact Fibrolan support