FibroLAN Falcon-RX/812/G/A User Manual page 31

Falcon R-Class | User Guide
Cable Type
Advertise Duplex
Advertise Speed
Flow Control
PFC
Maximum Frame Size
Excessive Collision Mode Configure port transmit collision behavior:
31
AutoSFP interface in "auto" mode. Automatic SerDes tuning for optical
and DAC-3m cables.
DAC-1mSFP interface in "DAC-1m" mode. Manual SerDes tuning
specifically for DAC-1m cables.
DAC-2mSFP interface in "DAC-2m" mode. Manual SerDes tuning
specifically for DAC-2m cables.
DAC-3mSFP interface in "DAC-3m" mode. Manual SerDes tuning
specifically for DAC-3m cables.
DAC-5mSFP interface in "DAC-5m" mode. Manual SerDes tuning
specifically for DAC-5m cables.
When duplex is set as auto i.e., auto negotiation, the port will only
advertise the specified duplex as either FDX or HDX to the link partner.
By default, port will advertise all the supported duplexes if the Duplex
is Auto.
When speed is set as auto, i.e., auto negotiation, the port will only
advertise the specified speeds (10M, 100M, 1G, 2.5G, 10G, 25G) to the
link partner. By default, port will advertise all the supported speeds if
speed is set as Auto.
When "Auto Speed" is selected for a port, this section indicates the
flow control capability that is advertised to the link partner.
When a fixed speed setting is selected, traffic that is what is selected.
Current Rx: This column indicates whether pause frames on the port
are obeyed.
Current Tx: This column indicates whether pause frames on the port
are transmitted.
The Rx and Tx settings are determined by the result of the last Auto-
Negotiation.
Configured: Check the configured column to use flow control; this
setting is related to the setting for Configured Link Speed. NOTICE: The
100FX standard does not support Auto Negotiation, so when in 100FX
mode the flow control capabilities will always be shown as "disabled".
When PFC (802.1Qbb Priority Flow Control) is enabled on a port then
flow control on a priority level is enabled. Through the Priority field,
range (one or more) of priorities can be configured, e.g., '0-3,7' which
equals '0,1,2,3,7'. PFC is not supported through auto negotiation. PFC
and Flow control cannot both be enabled on the same port.
Enter the maximum frame size allowed for the switch port, including
FCS. The range is -9600 bytes.
1518
Discard: Discards frame after 16 collisions (default).
Restart: Restarts backoff algorithm after 16 collisions.