Dynamic Dhcp Snooping - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Table 5-10: Snooping Configuration Parameters
DHCP Snooping Configuration
Snooping mode Indicates the DHCP Snooping mode of operation. Possible modes are:
Enabled: Enable DHCP snooping mode operation. When DHCP snooping
mode operation is enabled, the DHCP request messages will be forwarded
to trusted ports and only allow reply packets from trusted ports.
Disabled: Disable DHCP snooping mode operation.
Port Mode Indicates the DHCP snooping mode. Possible modes are:
Configuration
Trusted: Configures the port as trusted source of the DHCP messages.
Untrusted: Configures the port as untrusted source of the DHCP messages.

Dynamic DHCP Snooping

This page display the dynamic IP assigned information after DHCP Snooping mode is disabled.
All DHCP clients obtained the dynamic IP address from the DHCP server will be listed in this table
except for local VLAN interface IP addresses. Entries in the Dynamic DHCP snooping Table are shown
on this section
Web GUI: Monitor > DHCP > Snooping Table
Figure 5-12: Dynamic DHCP Snooping Table
Table 5-11: Dynamic DHCP Snooping Table Parameters
Dynamic DHCP snoopingTable
MAC Address
VLAN ID
Source Port
IP Address
IP Subnet Mask
DHCP Server Address
Navigating the DHCP snooping Table
Each page shows up to 99 entries from the, Dynamic DHCP snooping table, default being 20,
selected through the "entries per page" input field. When first visited, the web page will show the
first 20 entries from the beginning of the Dynamic DHCP snooping Table. The "MAC address" and
"VLAN" input fields allows the user to select the starting point in the Dynamic DHCP snooping
Table.
267
User MAC address of the entry
VLAN-ID in which the DHCP traffic is permitted
Switch Port Number for which the entries are displayed
User IP address of the entry
User IP subnet mask of the entry
DHCP Server address of the entry