FibroLAN Falcon-RX/812/G/A User Manual page 206

Falcon R-Class | User Guide
Web GUI: Configuration > IPMC > MLD Snooping > VLAN Configuration
Figure 4-148: MLD Snooping VLAN Configurations
Table 4-142: MLD Snooping VLAN Configuration Parameters
VLAN ID The VLAN ID of the entry.
MLD Snooping Enable the per-VLAN MLD Snooping. Up to 511 VLANs can be selected for MLD
Enabled Snooping.
Querier Election Enable the MLD Querier election in the VLAN. Disable to act as a MLD Non-
Querier.
Compatibility Compatibility is maintained by hosts and routers taking appropriate actions
depending on the versions of MLD operating on hosts and routers within a
network. The allowed selection is: MLD-Auto, Forced MLD v1, Forced MLD
v2. Default compatibility value is MLD-Auto.
PRI Priority of Interface. It indicates the MLD control frame priority level
generated by the system. These values can be used to prioritize different
classes of traffic. The allowed range is 0 (best effort) to 7 (highest), default
interface priority value is 0.
RV Robustness Variable. The Robustness Variable allows tuning for the expected
packet loss on a LINK. The allowed range is 1 to 255, default robustness
variable value is 2.
QI Query Interval. The Query Interval is the interval between General Queries
sent by the Querier. The allowed range is 1 to 31744 seconds, default query
interval is 125 seconds.
QRI Query Response Interval. The Maximum Response Delay used to calculate
the Maximum Response Code inserted into the periodic General Queries. The
allowed range is 0 to 31744 in tenths of seconds, default query response
interval is 100 in tenths of seconds (10 seconds).
LLQI Last Listener Query Interval. The Last Listener Query Interval is the Maximum
Response Delay used to calculate the Maximum Response Code inserted into
Multicast Address Specific Queries sent in response to Version 1 Multicast
Listener Done messages. It is also the Maximum Response Delay used to
calculate the Maximum Response Code inserted into Multicast Address and
Source Specific Query messages. The allowed range is 0 to 31744 in tenths of
seconds, default last listener query interval is 10 in tenths of seconds (1
second).
URI Unsolicited Report Interval. The Unsolicited Report Interval is the time
between repetitions of a node's initial report of interest in a multicast
address. The allowed range is 0 to 31744 seconds, default unsolicited report
interval is 1 second.
206