Detailed Udld Status For Port 1 - FibroLAN Falcon-RX/812/G/A User Manual

Falcon R-Class | User Guide
Table 4-175: UDLD Port Configuration parameters
UDLD Port Configuration
Port Port number of the switch.
Configure the UDLD mode on a port. Valid values are Disable, Normal and
UDLD Mode
Aggressive. Default mode is Disable.
Disable: In disabled mode, UDLD functionality doesn't exists on port.
Normal: In normal mode, if the link state of the port was determined to be
unidirectional, it will not affect the port state.
Aggressive: In aggressive mode, unidirectional detected ports will get
shutdown to bring back the ports up, need to disable UDLD on that port.
Message Configures the period of time between UDLD probe messages on ports that
Interval are in the advertisement phase and are determined to be bidirectional. The
range is from 7 to 90 seconds (Default value is 7 seconds) (Currently default
time interval is supported, due to lack of detailed information in RFC 5171).

Detailed UDLD Status for Port 1

This section displays the
Web GUI: Configuration > UDLD
Figure 4-184: UDLD Status for Port 1
Table 4-176: UDLD Status for Port 1 parameters
UDLD Port Status
UDLD Admin State
Device ID (local)
Device Name (local)
Bidirectional State
Neighbor Status
Port
Device ID (local)
Link Status
Device Name (local)
256
status of the selected port
UDLD
The current port state of the logical port, is Enabled if any of state
(Normal, Aggressive) is Enabled.
The ID of Device.
Name of the Device.
The current state of the port.
The current port of neighbor device.
The ID of neighbor device.
The current link status of neighbor port.
Name of the neighbor device.