FibroLAN Falcon-RX/812/G/A User Manual page 142

Falcon R-Class | User Guide
Global Configuration
Timeout
Retransmit
Deadtime
Change Secret Key
NAS IP Address
(Attribute 4)
NAS IPv6 Address
(Attribute 95)
NAS Identifier
(Attribute32)
Server Configuration
The table has one row for each RADIUS Server and several columns listed below.
Delete
Hostname
Auth Port
Acct Port
Timeout
Retransmit
Change Secret Key
142
Timeout is the number of seconds, in the range
reply from a RADIUS server before retransmitting the request.
Retransmit is the number of times, in the range
request is retransmitted to a server that is not responding. If the server
has not responded after the last retransmit it is dead.
Deadtime, which can be set to a number between
the period during which the switch will not send new requests to a server
that has failed to respond to a previous request. This will stop the switch
from continually trying to contact a server that it has already determined
as dead. Setting the Deadtime to a value greater than 0 (zero) will enable
this feature, but only if more than one server has been configured
Specify to change the secret key or not. When "Yes" is selected for the
option, you can change the secret key - up to 63 characters long - shared
between the RADIUS server and the switch.
The IPv4 address to be used as attribute 4 in RADIUS Access-Request
packets. If this field is left blank, the IP address of the outgoing interface
is used.
The IPv6 address to be used as attribute 95 in RADIUS Access-Request
packets. If this field is left blank, the IP address of the outgoing interface
is used.
The identifier - up to 253 characters long - to be used as attribute 32 in
RADIUS Access-Request packets. If this field is left blank, the IP address
of the outgoing interface is used.
To delete a RADIUS server entry, check this box. The entry will be deleted
during the next Save.
The IP address or
hostname
The UDP port to use on the RADIUS server for authentication. Set to 0 to
disable authentication.
The UDP port to use on the RADIUS server for accounting. Set to 0 to
disable accounting.
This optional setting
Leaving it blank will use the global timeout value.
This optional setting overrides the global retransmit value. Leaving it
blank will use the global retransmit value.
Specify to change the secret key or not. When the checkbox is checked,
you can change the setting overrides the global key. Leaving it blank will
use the global key.
1
of the RADIUS server.
overrides the global
to , to wait for a
1000
to , a RADIUS
1 1000
to minutes, is
0 1440
timeout value.